Installing
WARNING!
When the sensor is turned on, a 6-digit pin code will be displayed on the screen after booting up. Write down or memorize the pin code, you will need it when activating the sensor.

Connect your sensor to mains power.
Before starting the installation process, make sure that NeboAir is close to your mobile device to avoid problems with the Bluetooth connection.

On the home screen in the upper right corner, select the application setup icon. The color of the screen may vary depending on the air pollution.
Select Connect to NeboAir.
The NeboAir List screen will display the names of all NeboAir sensors within Bluetooth range of your mobile device. Select the sensor whose last six digits match your device ID. You can find this 12-digit alphanumeric ID on the box your NeboAir comes in.

The app will need to provide access to the location in order to search for sensors.
When your NeboAir is connected, you will be taken to this screen. Here you can monitor the sensor readings in real time.
In order to connect the NeboAir to the nebo.live open network and to be able to configure the data display, you need to activate the sensor. Click on the "Activate" button.

The sensor will then ask for a 6-digit pin code (pop-up window), which must be entered. Without the pin code, the sensor will not activate on the network and will not appear on the card. If you don't know the pin code - disconnect the sensor from the power supply and turn it on again.
What should I do if the pop-up window for entering a pin code did not appear?
  1. Swipe down from the top of the screen.
  2. Tap and hold Bluetooth.
  3. Locate the device named "Nebo-xxxxx" under "Available Devices", tap More - Update if necessary .
  4. Tap the sensor name.
  5. Enter the pin code for pairing.
  6. Return to the Nebo App and reconnect to the sensor. If necessary, reboot NeboAir - unplug the sensor and plug it in again.
After you enter the sensor pin code, you will see a list of Wi-Fi networks in a new window. Select the desired one and enter the network password.
It may take a few minutes to activate the sensor. If your sensor was successfully activated, you will see this screen. Congratulations!
If the activation did not happen, check that the password for the wifi network is correct and that the Internet is available on the router. Try again.
Now disconnect the sensor from the power supply. Open the sash of your window.
Attach the magnet to the glass, having previously cleaned the connection place.

Remove the protective film from the screen surface and place the sensor with the screen on the glass, connecting the magnet to the hole on the screen.

Run the power cable between the frame and the rubber window seal sash. Connect the USB cable to the power supply.

The window sash can be closed. NeboAir will show you what you are breathing outside!
Setting up
The sensor screen shows 2 indicators, one on the left and one on the right of the instrument display. They should be green and blue when the device is operating normally.

To see the status of the device, click on the icon on the left.
To change the instrument settings, tap the icon in the upper right corner.
"NeboAir Settings. On this screen you can change the display settings on the screen, update the software, and specify a new Wi-Fi network.